We are designing and testing BQ40Z50 with a 4s34 configuration li-ion battery pack system. We wish to reconfigure BQ40Z50 using BQSTUDIO. The issue is we couldn't find out how to make BQSTUDIO talk to ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

I am using MMWave studio to collect data for AWR1843. The previous setup steps were fine, but after clicking on the DAC1000 ARM, no. bin file was generated and the log prompted "No LVDS data" (as ...

Customer use LM1117I, Vin=7V, Vout=5V, Iout=0.6A. They test temperature of the IC case is 70℃， but the Vout decrease to 0 quickly. 1. At the operating point you mentioned, the power dissipation is ...

The difference between case 1 and case 2 with open circuit output lies in whether the output capacitance is large or small. How to determine whether the output capacitance is large or small, and is ...

I was wondering if it is possible to use a RTD instead of a thermocouple with this chip or are there other chips available able to do the same job as the ADS1118 but with a RTD. Thanks for ...

Uploads a binary file to the Flash memory, via SPI, then clears the flag and resets Makes the jump to the aplication uint32_t transferAddress; // Address that is ...

My customer has a question about SD pin. I would be grateful if you could advise. According to the LMH6601 datasheet, p. 20, 7.2.1 Shutdown Capability and Turn On/Off Behavior, If SD_Pin (5PIN) is not ...

I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this. here is our pin definition ...

I define the function, which calls the library functions, to be stored before start in the FLASH and copy during start of the program to RAM. *the function itself is copied to the RAM and the PC goes ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Hi, I download Pspice model of TAS5411-Q1 from your website. However it can't simulate and shows the error below. From another FAQ, I see that PSpice must delete the ...