Top Mount Ring Height Guide Dovetail Ring Height Guide Tactical Style Ring Height Guide Ring Size Saddle Height 30MM High .490" Thru 44mm 30MM X-High .610" Thru 56mm 34MM Low 0.327 Thru 24mm 34MM High .0.577" Thru 44mm 34MM XX-High 0.827" Thru 56mm. ... NOTES WEAVER® RINGS MOUNT
Weaver Optics
Download the Weaver Mounts Chart PDF for mounting recommendations and part numbers for popular firearm makes and models.
ð ó ó ì ô î r d µ v r/ v r t ] v ó ì Z ( ] o ^ o } À ] o h^ ð ó ó ì õ î r d µ v r/ v r t ] v yWZ Z ( ] o ^ o } À ] o h^
before shooting firearm, be sure scope and mounts are attached securely and correctly aligned FOR ACCURATE SIGHTING. WHEN SHOOTING WITH SCOPE OR IRON SIGHTS, BE SURE BUTTSTOCK OF GUN IS HELD FIRMLY
Mount the rifle and look through the scope in your normal shooting position. • Test position the rifle for the proper cheek weld a number of times to ensure that your scope is positioned properly. • When you are satisfied that everything is okay, demount and start again.
place mount ring saddle (bottom portion of mount) on the base(s) and push forward so the saddle crossbolt contacts the forward edge of the GROOVE IN THE MOUNT BASE. TIGHTEN SADDLE TO BASE WITH APPROPRIATE SIZE SCREWDRIVER TO …
The Weaver type base built into this firearm will accept any Detachable Top Mount Weaver Ring. 12 Rifle has Grooved Receiver for Tip-Off Rings. 13 Ruger Mark II Pistols. Weaver only offers a clamp on base with 1" rings (Pistol Mount System #306). Ruger supplies a short or long base and 1" or 30mm rings w/factory drilled and tapped pistols.
CLASSIC SEE THRU LOCK RING MOUNTS WARNING: UNLOAD FIREARMS BEFORE INSTALLATION TO PREVENT SHOOTING ACCIDENTS. 49713 5. Tightening Cap Screws. Alternate tightening the four cap screws evenly, a little at a time, until secure.
refer to ring and scope manufacture recommended mounting instructions to finish scope installation. *SOME FIREARMS REQUIRE THE USE OF TWO DIFFERENT LENGTH BASE SCREWS. IF A BASE SHIPS WITH TWO DIFFERENT LENGTH …
MOUNTING INSTRUCTIONS FOR USE ON .22 RIMFIRE RIFLES WITH FACTORY GROOVED RECEIVERS (3/8”) ONLY. 1. Assemble saddle, clamp, clamp screw (Fig. 1). 2. Position loosely assembled saddles in receiver grooves. Tighten clamp screw securely. 3. Place scope on saddles. Place ring caps over the scope tube and line up holes with holes in saddles.